How To Use Easyblast
EASYBLAST is a Non-explosive, Non Toxic Chemical Demolition Agent that safely and silently cracks rocks and concrete in three easy steps: Drill, Mix, Pour.
Preparation before using Easyblast
First measure the temperature of the jobsite, demolition agent, water, stone/concrete and container to ensure temperatures are in accordance with compliance requirements.
✔ Demolition agent
✔ Clean and cold water
✔ Plastic or metal bucket
✔ Beater or wooden rod for mixing
✔ Safety goggles
✔ Rubber gloves
✔ Dust proof mask (recommended)
✔ Helmet (recommended)
✔ Thermometer (recommended)
✔ Drill holes using an air hammer drill and appropriate drill bit specific to the rock and concrete type.
✔ Holes should be drilled no further than 30-60cm (1 ft – 2ft) apart.
✔ In reinforced concrete recommended no more than 20cm (8″) apart.
✔ Recommended hole diameter 38mm-50mm (1 1/2″ – 2.0″) .
✔ Depth would be 70-90% of the way depending on the type of rock/material to be removed.
Note: Do not exceed 50mm diameter drill size
✔ For regular safety reasons and mixing small amounts by Hand, it is recommendable to use rubber gloves.
✔ In a bucket, combine 1.5 Liters of water to one 5kgs bag of easyblast.
✔ Mix well, using a drill and paddle is recommended . If mixing with a stick or other method, make sure powder is completely dissolved into the water. Mix to the slurry
✔ Clean holes before filling using air hose remove excess dust from drilling.
✔ CRACKING slurry should be poured into holes within 10-15 min, after mixing. Do not fill to the top , only fill the holes about 15mm (1/2″ to 1 ) from the top.
✔ Mix well and pour into holes while agitating the hole to make sure no air gaps are in the hole. Example: Using a piece of rod or stick to poke holes.
✔ For Horizontal holes, a grouting pump would be most reliable to pour.
Note: If there is any personal injury or possession loss caused by disobeying the instructions, our company doesn’t take any economic and legal responsibilities.